Astro Spectra Plus

From W3AXL Wiki
Jump to navigationJump to search

The Astro Spectra Plus is a variant of the Astro Spectra with an upgraded vocon to allow it to run on Astro25 firmware and be programmed by the Astro25 CPS.

Hardware

RS232 Programming

The ASP can be programmed using a straight-through RS232 serial connection using either the rear DB15 on mid-power units or the front DB25 on high power units. The pinouts for the cable using a standard female DB9 connector on the computer side are shown below.

Signal Computer DB9 Mid-Power DB15 High-Power DB25
RXD 2 11 2
TXD 3 13 3
CTS 8 1 17
RTS 7 15 4
GND 5 8 18

Additionally, some jumpers may need to be moved as some ASP units were shipped without RS232 functionality on the ports. The detailed service manual gives a chart for non-RS232 jumper placement, and reversing these jumpers will re-enable RS232 operation.

Software

Available Flashcode Options

Out of Band

See Astro Spectra#Out of Band for information as the Plus shares the same VCO hardware.

P25 Out of Band Limitations

Unfortunately for those wishing to use P25 in the ham bands, there is a firmware restriction for the UHF-R and VHF-K bandsplit radios which prevents the vocon from modulating P25 below 450 and 148 MHz, respectively. This firmware limitation can be worked around by directly editing the codeplug partition, but unfortunately this requires tools even more advanced than standard Astro25 Depot.