BCD996P2 Internal GPS Mod

Preface

The following article demonstrates a "quick-n-dirty" approach to adding an internal GPS receiver to a BCD996P2. This was a small project I completed in a single evening when my OEM Uniden GPS "puck" bit the dust. I had a few NEO-6M GPS modules from eBay lying around from some other projects, so I figured it would be relatively trivial to throw one inside the 996 case. There's a lot of room in there.

Parts Required

• NEO-6M/7M/8M GPS Module from eBay, AliExpress, or similar "reputable" online sellers. Important bits to consider are that it can be powered by 3.3V and all logic inputs/outputs are 3.3V. You could probably use many other GPS modules. As long as they output standard NMEA data at TTL levels, they'll be usable in this application. Don't forget, you'll want to get one with an external antenna connector (typically u.Fl) so you can route the antenna out of the case.
• SMA Bulkhead Jumper, again sourced from your favorite online seller. This is how I added the external GPS input to the rear panel of the 996. You can do this however you see fit, I just driller out the rear M4 screw hole to install the bulkhead.
• Suitable Wire for connecting everything up. You need three wires, about six inches each.
• Mounting Tape/Glue to secure the bodge wires and the module. You don't want these things just rattling around inside the case. Well, maybe you do, but us normal folks like peace and quiet when driving around town.
• (optional) Pin Header & Socket for allowing the GPS module to be removed for programming/debugging. My modules came with headers, but the socket I had lying in a parts drawer.

The Mod Photos

I present the following photos, with minimal context, in the hopes that they will be a suitable replacement for a large wall of text that I'm too lazy to write at the moment.